Clear-Com TEMPEST 2400 Especificaciones descargar pdf (Pagina 80)

100

Clear-Com Communication Systems Page 80 of 100

Tempest 2400 Wireless Intercom System

the back of the base station.

If all connections are made correctly with all front panel controls properly set, and there is still no external

hardwired intercom audio present in the Tempest system, substitute another cable (3-PIN XLR for 2-Wire

or RJ-45 for 4-Wire) making sure that it is connected properly to both the external hardwired system and

the Tempest base station.

Perform the above tests on another intercom channel. If using 2-Wire on channels A or B, try the test on

channel C or D. If possible, test with another wired intercom system.

Headset microphone sounds distorted or cuts off parts of words

If the microphone gain is set too low for the specific headset microphone being used, the audio coming

from that microphone may sound choppy or clip off the first part of words or sounds.

If the microphone gain is set too high for the specific headset microphone being used, the audio coming

from that microphone may sound distorted at higher audio levels. In this case the peak LED will light

almost continuously when audio is present.

There is no audio passing when not using an external hardwired intercom system

and Tempest base stations are sharing intercom channels.

Confirm that no wired intercoms are connected to the system.

Confirm a 3 pin XLR cable connection for each channel (A – D) to be shared, between each of the base

stations.

Set all of the base station 2-Wire Intercom Type Select Switches to the Clear-Com position.

Select 2-Wire for the relevant channels.

Set only one of the Tempest base stations to Master Mode.

There is no audio passing when using an external hardwired intercom system

and Tempest base stations are sharing intercom channels.

Confirm a 3 pin XLR cable connection for each channel (A –D) to be shared, between each of the base

stations.

Set all of the base station 2-Wire Intercom Type Select Switches to the appropriate position.

Select 2-Wire for the relevant channels.

For each channel to be shared, connect the wired intercom to one of the base stations.

iSelect roaming not functioning

Confirm that the beltstation has been paired with all required base stations.

Select the desired base station from the beltstation menu: Press MENU, select “Select Base”, select the

desired base station.

If the beltstation name does not appear on the Base’s LCD, confirm that there is an available slot on the

desired base station. If no slot is open, power off one of the connected beltstations, wait for 15 seconds,

and try again.

Audio can only be passed from one base station to another in the “Clear-Com mode” unless

actually connected to another type of intercom system.

Connecting any wired intercom to any base station will automatically disable Master Mode and

disconnect all shared channels that do not have a wired intercom connected.

When connecting any shared base stations to any wired intercom system, only channels

connected to the wired system can be shared.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Comentarios a estos manuales

Sin comentarios

Clear-Com TEMPEST 2400 Especificaciones Pagina 80

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta Clear-Com TEMPEST 2400