Clear-Com TEMPEST 2400 Especificaciones descargar pdf (Pagina 70)

Clear-Com Communication Systems Page 70 of 100

Tempest 2400 Wireless Intercom System

Name Equipment

Name the base station with a descriptive name which will appear on the beltstation LCD display. This is

most helpful when iSelect Roaming will be used to roam between base station coverage areas. The base

station name can include up to 14 characters.

Name each beltstation with a descriptive name. Until the name is changed a hexadecimal serial number

is displayed. The first six characters of the beltstation name will be displayed on the base station LCD

display. Naming is a personal preference option and is not essential.

Personal Preferences

To configure each beltstation, adjust any of the following to suit individual needs. None of these

adjustments are required. Note that more options are available under the “Set Controls” menu and

become visible by scrolling.

• “Lock Keys” to prevent inadvertent changes.

• Disable “Battery Alert” to prevent the battery alert tone in the headset.

• Dim the LCD and LEDs to be less conspicuous in a dark environment.

• Limit talking to push-to-talk mode by selecting “Momentary”. “Latch” is the default.

• Disable the ability to talk on any channel, but allow listening.

• Disable the ability access any channel not required.

• Adjust minimum and maximum volume levels. In loud environments a higher minimum volume

may be desirable, while in quiet environments a lower maximum volume may be preferable.

• When Stage Announce functionality is enabled in the base station, the STAGE button can be

disabled for individual beltstations.

• The CALL alert can be set to tone or vibrate. The default is “Both”.

• When relay functionality is enabled in the base station, select the relay to be activated by the

beltstation. Then select the beltstation control that will activate the relay.

• Wireless ISO can be disabled, if desired.

Call Function

Press MENU, select Set Controls, select Call Button, and select Enable. This is the default setting.

Press MENU, select Set Controls, and select Call Alert. Choose to receive a Call signal alert with tone in

the headset, or with a vibration of the beltstation or both. The default setting is Both.

Select a channel for talking with the channel select CH AB or CH CD and activate the TALK button. Press

and hold CALL for as long as you want the Call signal to go out on the channel.

A Call signal will be received by users who are listening on the channel that originates the Call signal.

A call signal is sent only when the Talk button is enabled, only on the channel selected for

Talk.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 99 100

Sin comentarios

Clear-Com TEMPEST 2400 Especificaciones Pagina 70