Clear-Com TEMPEST 2400 Especificaciones Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
Clear-Com Communication Systems Page 66 of 100
Tempest 2400 Wireless Intercom System
Beltstation Setup
Steps to Setup the Beltstations
Install the battery.
“Pair” beltstations to the base station.
Adjust slot settings as needed.
Connect a headset.
Adjust Mic Gain.
Adjust Sidetone.
Configure optional features
1. Name the beltstation
2. Disable unused functions, channels, and buttons.
3. Select/disable relay options as needed.
4. Adjust personal preferences.
Battery Selection and Installation
The Tempest beltstation battery compartment holds either one Tempest
Lithium-Polymer rechargeable battery or three standard alkaline AA cells.
Lithium-Polymer batteries are the primary power source. High quality
alkaline AA cells may be used in situations where Lithium-Polymer
batteries are not available or are not charged. One Lithium-Polymer battery
comes standard with each Tempest. Additional Lithium-Polymer batteries
may be purchased. Contact your dealer to purchase additional batteries.
The Lithium Ion batteries supplied with your Tempest Wireless system are
warranted for 90 days from the date of purchase.
Lithium-Polymer batteries offer up to 9 hours of battery life and recharge in approximately 2¾ hours.
Lithium-Polymer batteries ship from the factory with approximately 50% charge. It will not damage the
Lithium-Polymer batteries to use them without charging them first. This will, however result in shorter run
time until the Lithium-Polymer battery is fully charged. When possible, charge Lithium-Polymer batteries
to full capacity to ensure full battery life prior to use.
Using 3 alkaline AA batteries can provide up to 4 hours of battery life. Use only high quality alkaline AA
cells. This will provide enough time to fully charge the Lithium-Polymer battery.
To remove the Battery Door, press down on the thumb markings and pull the Battery Door toward the
bottom of the beltstation.
To remove batteries from the Battery Compartment turn the beltstation battery side down and tap the
bottom of the beltstation on the palm of your other hand.
Please be careful to insert alkaline AA batteries according to the marked polarity. All of the alkaline AA
cells must be oriented the same direction.
If the battery cover does not close properly, the battery may not be inserted correctly.
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 99 100

Comentarios a estos manuales

Sin comentarios