Clear-Com TEMPEST 2400 Especificaciones descargar pdf (Pagina 40)

Clear-Com Communication Systems Page 40 of 100

Tempest 2400 Wireless Intercom System

4-Wire (Matrix) Intercom Interface

4-Wire intercom systems use two pairs of wires to carry one full duplex channel of intercom audio - one

pair for send and the second pair for receive. In addition to intercom audio, most systems have separate

data lines that carry system data from the matrix to the remote devices. The Tempest 4-Wire connection

is an audio-only interface to 4-Wire systems. Data can be present on the input cable but no data is

utilized in the Tempest base station.

Steps to Configure a 4-Wire Intercom Connection

• Select 4-Wire connection for the appropriate channels.

• Make the physical connections with RJ-45s, to the Tempest base station and the 4-Wire system.

• Configure the 4-Wire system to recognize the Tempest Wireless system.

• Adjust IN/OUT volume levels between the Tempest Wireless System and the 4-Wire system as

needed.

Connect the 4-Wire intercom system to the desired channel RJ-45 jack on the rear panel of the Tempest

base station. Select the 4-Wire setting as described in “Wired Intercom Configuration Controls” on page

39. That is all that is necessary for Tempest to be ready to communicate with the 4-Wire system. Perform

any necessary configuration for the 4-Wire intercom System and the communication link should be

complete.

The top RJ-45 jacks are for Channel A or C and the bottom RJ-45 jacks are for Channel B or D.

You may choose to adjust the In/Out levels on the front of the base station if the volume level between

the systems is not acceptable.

Wiring schemes vary and it is important to ensure that the cable is wired correctly for proper system

operation. Tempest utilizes RJ-45 jacks for 4-Wire connection to the base station. Only two pairs of wires

are utilized - one to send audio and one to receive audio. A standard CAT-5 patch cable can be used to

connect between the matrix and the Tempest system.

Tempest 4-Wire / RJ-45 Connection

Pin # Use

1 No Connection

2 No Connection

3 Audio Input (+)

4 Audio Output (+)

5 Audio Output(-)

6 Audio Input (-)

7 No Connection

8 No Connection

RJ-45 Jacks

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Sin comentarios

Clear-Com TEMPEST 2400 Especificaciones Pagina 40