Clear-Com TEMPEST 2400 Especificaciones descargar pdf (Pagina 63)

Clear-Com Communication Systems Page 63 of 100

Tempest 2400 Wireless Intercom System

Bottom view of the transceiver

Transceiver controls

RX LED

The RX LED illuminates when data is being received by the Remote Transceiver. This LED will remain

illuminated during normal system operation.

TX LED

The TX LED illuminates when data is being sent from the Remote Transceiver. This LED will remain

illuminated during normal system operation.

SYNC LED

The Sync LED illuminates when the Transceiver Sync signal is present. This LED will remain illuminated

during normal system operation.

CONFIG LED

The Config LED illuminates only when the base station puts the Remote Transceiver into configuration

mode to change settings. This LED should be on for only a few seconds when first powered on, and off

during normal operation.

Base Station Link RJ-45 Connector

The Base Station Link RJ-45 connector is used to connect the Transceiver to the Tempest base station

via standard CAT-5 cable with RJ-45 connectors.

Power LED

The Power LED illuminates whenever the base station is providing adequate power to the Transceiver

over the CAT-5 cable. If the Power LED does not light, The CAT-5 cable is damaged or too long to deliver

adequate power for the Transceiver to operate reliably.

Threaded Mounting Holes

Two Threaded Mounting Holes are provided on the back of the Remote Transceiver for use with the

mounting bracket to mount the Transceiver in a convenient location. The mounting holes are #8-32 thread

and accept a #8-32 x 3/8” pan head screw.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 99 100

Sin comentarios

Clear-Com TEMPEST 2400 Especificaciones Pagina 63