Clear-Com TEMPEST 2400 Especificaciones descargar pdf (Pagina 14)

Clear-Com Communication Systems Page 14 of 100

Tempest 2400 Wireless Intercom System

4. Pair Beltstations to the Base Station

Pairing is a programming process that allows a base station and beltstation to

recognize each other.

• Confirm that the base station is powered on.

• Confirm that the beltstation is powered off.

• Connect the Pairing Cable from the base station to a beltstation.

• Power on the beltstation and watch the beltstation display for “Pairing

Complete”.

• Turn the beltstation off and back on again.

• Beltstation status will become visible on the base station display.

• Repeat with each beltstation.

5. Connect Headsets to Beltstations

Plug a headset into each beltstation, and the base station if desired.

6. Operation

Select a channel on the beltstations by pressing the CH A/B or CH C/D control.

Press the TALK button. A quick press latches the Talk button for “Hands Free”

operation. Press and hold the Talk button for more than 2 seconds while you talk and

the button will release in a Push‑To‑Talk manner.

Set the volume by rotating the CH A/B or CH C/D control.

You may confirm beltstation operation on the base station

Operation screen. There is a section for each beltstation. In this

illustration, each beltstation is set to talk on channel A and listen

on channels A & D, with only three beltstations in operation.

A headset may be connected to the front of the base station. Activate by pressing the TALK button.

Select a channel by pressing the volume knob.

• Refer to the user manual for detailed instructions regarding:

• Country limitation on 2.4GHz RF spectrum. See page 30 for details.

• Adjusting the Network Number and Lockout Key on page 31.

• Assigning names for equipment on page 32.

• Charging batteries on page 67.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Sin comentarios

Clear-Com TEMPEST 2400 Especificaciones Pagina 14